英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • E90 cranks but wont start, no communication with DME
    The majority of your Fault Codes indicate that "No Message" was received by the EKPS, DSC, or VGSG VTG from the DME Those other Modules are operating fine; its the DME (Transmitting Sending Module) that is at issue For there to be "Communication" with a particular Module, such as the DME, TWO things are needed: 1) Power Supply to the Module (keep that thought ;-) 2) Bus Communication
  • e39 DME replacement!! HELP!! - BimmerFest BMW Forums
    The DME is the top (closest to the firewall) module I believe Unplug the harnesses and presto, your DME is free Your EWS is located underneath your steering wheel on the left hand side You'll need to take off your lower dash piece to gain access if I remember correctly It's held on with two screws
  • E92 335i Possible Fried DME Electrical Issue - BimmerFest BMW Forum
    C) DME Grounds, X6454; D) Location of Fuse Carrier A8680 DME Main Relay K6300 in E-box; E) Connector View of DME Main Relay K6300 Socket; F) Location of F06 10Amp fuse in E-box Hopefully, this will get you started Please answer the questions above, and let us know if we can suggest tests methods, provide further ISTA info, etc
  • Bad DME? | BMW Forum - BimmerFest BMW Forums
    Could be a bad DME, bad wiring, missing supply or ground The answer below the codes states that the valvetronic motor killed the DME output but I don't think that's the case since there is another message stating that the position sensor isn't readable, which is not related to the motor issue Plus the DME outputs are well protected
  • No communication from DSC to DME - BimmerFest BMW Forum
    No communication from DSC to DME 1 reading Jump to Latest 7 1K views 4 replies 3 participants last post by rickyboy_99 Sep 28, 2023
  • Bmw e39 only starts with ews dme sync. . . . HELP
    usually a loss of EWS-DME sync is a result of the battery being disconnected for a period of time, 2 weeks or longer or the battery getting run way down and the car left that way Click to expand I know, but the battery is new from bmw, and it was running normally when this start issue occurred Not sure why it occurs
  • Gearbox fault (EGS, DSC, KOMBI, DME fault) - BimmerFest BMW Forum
    Long first start (this is normal when the data bus is shaking) After the engine started, I see in the diagnostics that the blocks (DSC, DME, EGS, SZL, SFZ - all after SGM SIM on bus) on PT-CAN are falling off The dashboard does not display the gear, engine tachometer is dead, economizer, etc Fault in the gearbox, stabilization, ABS, steering
  • What is a DME Control Module? - BimmerFest BMW Forum
    DME verifies all incoming data by comparing it with the reaction of the rest of the system If a defective sensor delivers unrealistic data, DME replaces this with preset standard values If a spark plug fails, DME immediately cuts fuel flow to this cylinder in order to prevent engine damage
  • Help with a lot of DME Codes - BimmerFest BMW Forum
    No DME 2 is the slave DME on Bank 2, driver side DME 1 is on passenger side Ended up being a loose pin in one of the harnesses to DME 2
  • HELP!!! DME code 1B5102 Term 15. 3 line from CAS short to. . .
    Hi guys! I need help to move forward with this issue We have now 2x BMW F02 730iL (C951611 and CN74784) with the same code stored in DME : 1B5102 Terminal 15 3,line from CAS,eletrical circuit short to ground Both vehicles shut off while was driving and did not able to start back up Crank no





中文字典-英文字典  2005-2009