英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字,中文词皆可:


请选择你想看的字典辞典:
单词字典翻译
1406查看 1406 在百度字典中的解释百度英翻中〔查看〕
1406查看 1406 在Google字典中的解释Google英翻中〔查看〕
1406查看 1406 在Yahoo字典中的解释Yahoo英翻中〔查看〕





安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • 1406 Edelbock - I did it,I figured it out, its all good now!
    tuning the jets and metering rods The problem is the stock 1406 carb is jetted so lean that you are starting from a whacked benchmark, so even the chart is misleading The 1406 has a stock tune of 098 jet and a 075 x 047 metering rod That's extremely lean in the cruise mode and can cause hesitation or a stumble as it transitions to power mode
  • Tuning an Edelbrock 1406 - A success story - Vintage Mustang Forums
    After years of building my 67 coupe from the ground up, I am to the stage of fine tuning At some point, after much googling, im sure, I decided on the Edelbrock 1406 for a 600cfm with an electric choke Older me regrets that decision I had what turns out to be lean issues from day 1
  • Edelbrock 1406 Step Down Spring question - Vintage Mustang Forums
    I changed rods today in my Edelbrock 1406 The tune kit has several optional step down springs that came in it I did not see any info in the manual about when to use which spring Can anyone give me the rundown on this? The carb and tune kit was used, so I am not sure if the springs that
  • Holley VS Edelbrock | Vintage Mustang Forums
    Correct, That is the set-up I have on my other 68 running the 1406 Edelbrock I looked at the M2008Vs600 of Summit, I did not like the dual gas line set-up, I would have to redo the gas line from pump and the brackets I would have to buy to make it work for me
  • Edelbrock 1406 tuning advice - Vintage Mustang Forums
    The 1406 tuning charts for the 1406 are still way too lean, and made fore fuel economy Joe in Detroit 1969 Mustang Sports Roof (SAG = Sports Appearance Group) 1 of only 5,729
  • edelbrock 1406 carb tuning help | Vintage Mustang Forums
    I could use a little help from those experienced with edelbrock carbs I have a 1406 600 cfm electric choke on my new engine I know that this carb is set lean for economy from the factory I have head that re-jetting it to the 1405 specs would be a good base line I have the tuning kit on
  • Edelbrock 1406 Throttle Linkage Help Needed - Vintage Mustang Forums
    Looking for guidance on a linkage solution for a 1406 on my 68 302 I purchased an Edelbrock Ford kit #1483 with the carb thinking that the kit would provide a means to connect my stock throttle arm with the 90 degree jog directly to the 1406 linkage However, the pics show this kit doesn't provide a means to attach the arm
  • 289 Edelbrock 1406 Tuning - Vintage Mustang Forums
    The stock 1406 config should be fine for a bone stock engine Have a look at the colour of the plugs to get an idea if its running rich or lean The other thing to check is that the throttle linkage opperates in its full range by foot as opposed to by hand That can make a big difference if you can only get 2 3 throttle but think its full throttle
  • Finally did the Jets and Rods in my Edelbrock Carb
    In an effort to do a little bit of tuning on my Edelbrock 1406, I upgraded the Jets and Rods Here's a VIDEO OF THE TUNE I started with a mild tune that really only turned my 1406 Carb into the 1405 I'll run it like this for a while and upgrade again if needed I plan to do a cam down the
  • Adjusting the electric automatic choke on an edelbrock?
    I recently installed a 1406 edelbrock on my 289 This carb comes with an electric choke that must be wired to a keyed 12 volt circuit - which I was able to do I find that when I start the car, there is way too much choke At idle, i rev at about 800 Yet when I start the car, this thing goes off the charts until I gently tap the accelerator pedal





中文字典-英文字典  2005-2009